Hello,
I purchased Galilsuite the other week and I am new to all of this. Is there any other source of documentation for this software? I am trying to find out how to set the encoder resolutions for my brushed DC servo motors and all I can find is a setting for stepper motor encoders. If you can point me to more learning resources for this product, I would be very grateful.
Andre Barclay.
rogerp on 03/02/2015 - 13:44
There are no engineering units built into the controller or software. Everything seen by the controller or software is in counts or steps. It is possible to write a subroutine to convert counts or steps into engineering units on the controller or have a function that does so in a host application. The getting started section of the manual and software manual are good resources for an introduction.
http://www.galil.com/download/manual/galilsuite/
http://www.galil.com/downloads/manuals-and-data-sheets
If you have any specific questions, please feel free to e-mail support.
Best,
Roger