Skip to main content
Submitted by EStevens on Wed, 10/04/2017 - 07:02

The IP address is reset every time the unit is powered down. I'm attempting to set it as follows:

IA 10,0,50,95
BN

After the initial IA command I can communicate just fine, but when power cycled I have to set the address again. BN doesn't seem to work.

Comments 1

andriys on 10/09/2017 - 14:14

The issue was resolved after contacting support@galil.com.

The IP address being set on the 2200 was being overwritten by the DMC program onboard the controller. This resulted in the IP Assignment changing once a power cycle occured.